Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Sweep Across Fort Washington
If you’re searching for a chimney sweep in Fort Washington, here’s the short answer: a basic annual sweep typically runs $180 to $280, a Level 2 camera inspection adds $150 to $250 on top, and most homes on the wooded streets off Bethlehem Pike and Susquehanna Road need the inspection before anyone touches a brush. That’s because Fort Washington’s dense oak and sycamore canopy fills caps, crowns, and flues with debris faster than most suburbs. We work Fort Washington as a chimney specialist, not a generalist passing through. Call (866) 861-1187. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Fort Washington Homeowners Call Chimney Sweep Rhawnhurst for Chimney Sweep
Fort Washington is an old, affluent, heavily wooded Montgomery County suburb, and the trade here is defined by that canopy. Most of the fireplaces we see sit in mature single-family homes built from the 1920s through the 1970s on large wooded lots. The recurring job isn’t soot buildup so much as wildlife and debris removal and cap repair, then the sweep that follows. That difference matters when you’re booking someone.
We’re a single-trade chimney company. Chimney work is all we do, so we do it right. We diagnose before we quote, and nothing gets recommended without camera evidence you can see for yourself. Our technicians have up to 15 years of experience, and every job runs from inspection through repair under one roof: sweep, cap and crown, liner, and fireplace repair. From annual sweep to full liner rebuild, one call covers it all. That scope is why we don’t hand off structural problems to a second contractor.
The local pro we connect you with is licensed and insured as their state requires. We give you a flat price for a sweep, agreed before booking, and a camera inspection with a photo report included.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Sweep Services in Fort Washington
Level 1 Inspection
A Level 1 inspection is the baseline check on a chimney you use regularly with no changes to the system. In Fort Washington it catches the early stuff: a spalling mortar crown, a hairline crack in a flue tile, debris sitting at the smoke shelf. It’s quick and it’s the right starting point for most annual visits.

Level 2 Inspection
A Level 2 inspection uses a camera down the flue and it’s the service that matters most in Fort Washington. In the dense postwar neighborhoods here, many homes share a chimney stack with a neighbor or have an appliance venting into a common flue. A camera shows whether a gas furnace or water heater is venting into the same flue as your fireplace, and whether cracked tiles or spalling mortar could let carbon monoxide from an adjacent appliance migrate into your living space. That cross-contamination condition is far less common in newer suburban developments with individual chimneys. A Level 2 is also what’s called for whenever a home changes hands, the appliance changes, or after a chimney fire.

Creosote Removal
Creosote builds in three degrees, and the third is the glazed, tar-like stage that’s genuinely a fire hazard. In Fort Washington, a humid continental climate with heavy leaf-fall means flues sit damp and idle through summer, which accelerates that buildup going into the heating season. We remove it with the right tools for the degree, and we tell you plainly when the glaze is thick enough that a sweep alone won’t handle it.

Soot Removal
Soot accumulates on the smoke chamber and flue walls and it’s the fine, sooty film that a brush and vacuum clear out. It’s part of every annual sweep we do in Fort Washington. Left alone it dulls the draft and coats the inside of the firebox. When the sweep is done we show you what came out.
Trusted Brands We Service in Fort Washington
When a repair or reline is called for, we install and work with professional-grade materials from DuraFlex, HeatShield, Gelco, and Olympia Chimney. These are the same brands specified by certified chimney professionals nationwide, and they matter for a simple reason: a reline is only as good as the liner system. HeatShield’s ceramic resurfacing gives Fort Washington homeowners a repair option before committing to full replacement, while DuraFlex covers the full reline when the flue tiles are too far gone. We don’t stock parts, so the right system is ordered for your job after the inspection, not before. Turnaround is quick once the diagnosis is set.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Sweep Problems We See in Fort Washington Homes
- Debris from the oak and sycamore canopy. Leaves, twigs, and windthrow clog the chimney cap and flue, causing poor draft and smoke spillage that can mimic a more serious venting problem. The debris often hides a cracked tile underneath.
- Shared or adjacent flues in attached properties. Smoke and carbon monoxide from one unit’s appliance can seep into a neighbor’s chimney, especially when flue tiles are cracked or mortar is spalling. It’s a quiet problem until someone smells it or a CO alarm sounds.
- Freeze-thaw damage on crowns and caps. Exposed crowns and caps take repeated freeze-thaw cycles here, leading to spalling mortar and cracked flue tiles that go unnoticed until a spring inspection turns them up. Spring is when the repair rush starts.
- Squirrel and bird nests under the mature oak. Squirrels and birds routinely nest in uncapped flues along the wooded streets off Bethlehem Pike and Susquehanna Road. A spring sweep often turns into a wildlife-eviction and cap-installation job before the first fall fire.
How a Typical Fort Washington Job Goes
When a homeowner lights the first fire of the season, smoke often backs into the room because the flue is blocked by a squirrel nest or a collapsed clay tile, damage that goes unnoticed until the draft fails. A qualified chimney sweep will run a Level 2 inspection with a camera, clear the debris, and assess the flue liner and smoke chamber for cracks or gaps that could let carbon monoxide from an adjacent appliance migrate into the living space. If the crown is spalling or the cap is missing, they’ll recommend a new cap and crown repair to keep the canopy’s oak and sycamore litter from starting the cycle again.
Pricing for Chimney Sweep in Fort Washington, PA
A typical annual sweep in Fort Washington runs $180 to $280, and a Level 2 camera inspection runs $250 to $450. Creosote removal on a heavily glazed flue runs $300 to $600. A cap and crown repair typically runs $350 to $900, and a full reline runs $2,500 to $5,500 depending on the flue length and liner system. What moves the price: how many flues serve the stack, whether the crown needs rebuilding or just sealing, and whether debris removal turns into a wildlife-eviction job. You get a flat price agreed before booking, and the written estimate sets the final price. Estimate is free. Call (866) 861-1187 to book one.
We Also Serve Cities Near Fort Washington
We connect homeowners across the surrounding area, including McKinley, Rockledge, Cheltenham Village, and Olney. If you’re in one of these towns, you can find our full service menu on our chimney sweep page. All of it runs from the same single-trade team.
Serving Fort Washington, PA – Our Local Coverage Area
We serve Fort Washington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Sweep in Fort Washington
Yes. When a gas furnace or water heater vents into a shared flue, a cracked tile or spalling mortar can let carbon monoxide from that appliance migrate into your chimney and, from there, into your living space. It’s why we recommend a Level 2 camera inspection before relying on a shared stack. We answer 24/7; call (866) 861-1187 to book an inspection. Estimates are free.
Annual, even in years you don’t burn much. The dense oak and sycamore canopy here fills caps and flues with debris fast, and flues that sit damp and idle through summer accelerate mortar and tile deterioration. A yearly sweep catches it before fall. Call (866) 861-1187 for an exact quote.
First-degree creosote is the light, flaky soot a brush clears. Third-degree is the glazed, tar-like layer that’s a real fire hazard and needs proper removal, not a quick brush. Fort Washington’s damp summers make that glaze more likely. Call (866) 861-1187 and we’ll tell you what degree you’re looking at.
Yes. A spalling crown lets water into the flue, which cracks tiles and makes a sweep reveal damage that started at the top. We check the crown on every visit and can repair it at the same time or on a follow-up. Call (866) 861-1187 to schedule an inspection.
Yes, both. A Level 2 camera inspection is what’s called for when a home changes hands in Fort Washington, and it comes with a photo report you can hand to your agent or buyer. Call (866) 861-1187 to book it before closing.
Whether you’re in Fort Washington and just want a straight answer about your flue, or you’ve got a smoke backup and need it diagnosed, we can help. Call (866) 861-1187 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Rhawnhurst.